Zoll Propaq M Rev A User Manual

Propaq® M Service Manual9650-0804-01 Rev. ADecember 2010

CHAPTER 1MAINTENANCE TESTS6 9650-0804-01 Rev. AThis chapter describes the following maintenance tests:Calibration and Calibration Checks• NIBP Calibra

Calibration and Calibration Checks9650-0804-01 Rev. A ZOLL Propaq M Service Manual 7Calibration and Calibration ChecksNIBP Calibration CheckEquipment

CHAPTER 1MAINTENANCE TESTS8 9650-0804-01 Rev. AAcceptable ResultsThe unit passes the test if Pd-Primary is less than or equal to 3.0 mmHg and Pd-Safet

Calibration and Calibration Checks9650-0804-01 Rev. A ZOLL Propaq M Service Manual 9CO2 Calibration Procedure (required for annual calibration)Equipme

CHAPTER 1MAINTENANCE TESTS10 9650-0804-01 Rev. ACO2 Calibration Check ProcedureEquipment 5% CO2 calibration gas cylinder with CO2 sample line (kit ava

NIBP Valve, Pump, and Tubing Integrity Tests9650-0804-01 Rev. A ZOLL Propaq M Service Manual 11NIBP Valve, Pump, and Tubing Integrity TestsNIBP Leak T

CHAPTER 1MAINTENANCE TESTS12 9650-0804-01 Rev. ACorrective ActionIf the unit fails the test, the most likely cause is damaged or disconnected internal

NIBP Valve, Pump, and Tubing Integrity Tests9650-0804-01 Rev. A ZOLL Propaq M Service Manual 13NIBP Deflation TestEquipment Single lumen BP hose, a 50

CHAPTER 1MAINTENANCE TESTS14 9650-0804-01 Rev. A NIBP Inflation TestEquipment Single lumen BP hose, a 250 cc volume, a timer, and a calibrated manomet

Operational Tests9650-0804-01 Rev. A ZOLL Propaq M Service Manual 15Operational TestsThe Propaq M comes equipped with routine operational tests that c

ZOLL is a registered trademark, and SurePower is a trademark of ZOLL Medical Corporation. Propaq is a registered trademark of Welch Allyn, Inc. Nellco

CHAPTER 1MAINTENANCE TESTS16 9650-0804-01 Rev. AAccessing the Operational TestsThe operational tests on the unit can be accessed by doing the followin

Operational Tests9650-0804-01 Rev. A ZOLL Propaq M Service Manual 17Keypad TestThis test checks all the front panel buttons on the unit to make sure t

CHAPTER 1MAINTENANCE TESTS18 9650-0804-01 Rev. ALCD TestThis test checks the colors of the Liquid Crystal Display on the unit.Follow the instructions

Operational Tests9650-0804-01 Rev. A ZOLL Propaq M Service Manual 19Audio TestThis test checks the audio tones on the unit to make sure they are worki

CHAPTER 1MAINTENANCE TESTS20 9650-0804-01 Rev. AFan TestThis test checks the fan in the unit to make sure it is working correctly.Follow the instructi

Operational Tests9650-0804-01 Rev. A ZOLL Propaq M Service Manual 21USB TestThis test checks the USB capability in the unit to make sure it is working

CHAPTER 1MAINTENANCE TESTS22 9650-0804-01 Rev. AFunctional Verification TestsBefore You Begin the Functional Verification Tests• Assemble the tools li

Functional Verification Tests9650-0804-01 Rev. A ZOLL Propaq M Service Manual 23 Leads TestTools Needed 3-lead, 5-lead, and 12-lead cablesTest each ca

CHAPTER 1MAINTENANCE TESTS24 9650-0804-01 Rev. AHeart Rate Display TestTools Needed ECG simulatorECG Cable (3-lead, 5-lead or 12-lead) Test Setup Pres

Functional Verification Tests9650-0804-01 Rev. A ZOLL Propaq M Service Manual 25Heart Rate Alarm TestTools Needed ECG simulatorDo this... Observe this

9650-0804-01 Rev. A ZOLL Propaq M Service Manual iTable of ContentsPrefaceOverview...

CHAPTER 1MAINTENANCE TESTS26 9650-0804-01 Rev. A10. On the Propaq M, press the Alarm Suspend key ( ).Alarm is enabled. The alarm suspend key flashes.

Functional Verification Tests9650-0804-01 Rev. A ZOLL Propaq M Service Manual 27SpO2 TestTools Needed SpO2 Simulator: Fluke Index 2 or equivalent, Nel

CHAPTER 1MAINTENANCE TESTS28 9650-0804-01 Rev. AEtCO2 TestTools Needed CO2 sampling line airway adapterTest Setup NoneDo this... Observe this... Pass/

Functional Verification Tests9650-0804-01 Rev. A ZOLL Propaq M Service Manual 29IBP TestTools Needed IBP patient simulator (with accuracy better than

CHAPTER 1MAINTENANCE TESTS30 9650-0804-01 Rev. ANIBP TestTools Needed NIBP simulator, single or dual lumen hose, adult, NIBP cuff, rigid cylinderTest

Functional Verification Tests9650-0804-01 Rev. A ZOLL Propaq M Service Manual 31Temperature TestTools Needed IBP Temp Simulator, or equivalentTest Set

CHAPTER 1MAINTENANCE TESTS32 9650-0804-01 Rev. A

9650-0804-01 Rev. A ZOLL Propaq M Service Manual 33Chapter 2TroubleshootingOverviewThis chapter contains a list of error messages that users may see i

CHAPTER 2TROUBLESHOOTING34 9650-0804-01 Rev. AQUICK ACCESS SW 1 SHORTQuick access key 1 is stuck. Replace the front panel.QUICK ACCESS SW 2 SHORTQuick

Propaq M Error Messages9650-0804-01 Rev. A ZOLL Propaq M Service Manual 35TEMP PROBE2 SHORTED An A/D value was detected that indicated the probe was s

TABLE OF CONTENTSii 9650-0804-01 Rev. AChapter 5 Replacement PartsOverview...

CHAPTER 2TROUBLESHOOTING36 9650-0804-01 Rev. ANIBP MONITORING FAILUREOne of the following issues occurred:• A failure was reported by the NIBP module.

Propaq M Error Messages9650-0804-01 Rev. A ZOLL Propaq M Service Manual 37NIBP AIR LEAK Major air leak or could not reach target pressure.Attempt to i

CHAPTER 2TROUBLESHOOTING38 9650-0804-01 Rev. ANIBP NEONATAL DETECTEDDevice thinks a neonate cuff is connected. If no neonate cuff is connected, tubing

Propaq M Error Messages9650-0804-01 Rev. A ZOLL Propaq M Service Manual 39CO2 GAS INPUT OCCLUSIONCO2 inlet blocked.Replace FilterLine®. If problem per

CHAPTER 2TROUBLESHOOTING40 9650-0804-01 Rev. A

9650-0804-01 Rev. A ZOLL Propaq M Service Manual 41Chapter 3Disassembly ProceduresOverviewThis chapter provides instructions on how to disassemble and

CHAPTER 3DISASSEMBLY PROCEDURES42 9650-0804-01 Rev. A• 1/2” nut driver• Large diagonal cutters• Strong glue, such as Loctite 420 or equivalent• Loctit

Removing the Handle9650-0804-01 Rev. A ZOLL Propaq M Service Manual 43Removing the HandleTools Required• #1 Phillips screwdriver with torque capabilit

44 9650-0804-01 Rev. ADisassembling the Main UnitTool Required• # 1 Phillips screwdriver with torque capability• orange (wooden) stickSetup• This proc

Disassembling the Main Unit9650-0804-01 Rev. A ZOLL Propaq M Service Manual 456 Disconnect the battery communication cable (yellow, orange, brown, red

9650-0804-01 Rev. A ZOLL Propaq M Service Manual 1PrefaceOverviewZOLL® Medical Corporation’s Propaq® M Service Manual is intended for the trained biom

46 9650-0804-01 Rev. A11 Disconnect the NIBP tube from the rear case.NIBPhosesNIBP tube

Removing the Front Enclosure Module9650-0804-01 Rev. A ZOLL Propaq M Service Manual 47Removing the Front Enclosure ModuleTools Required• #2 Phillips s

48 9650-0804-01 Rev. A6 Remove the ZIF (Zero Insertion Force) flex cable using an orange stick.

Removing the Display Module9650-0804-01 Rev. A ZOLL Propaq M Service Manual 49Removing the Display ModuleTools Required• #1 Phillips screwdriver with

50 9650-0804-01 Rev. A5 Flip the unit back over so the display screen is facing up.6 Lift the casting up while pushing down on the rubber boot that ru

Removing the EtCO2 and NIBP Modules9650-0804-01 Rev. A ZOLL Propaq M Service Manual 51Removing the EtCO2 and NIBP ModulesTool Required• # 1 Phillips s

52 9650-0804-01 Rev. A3 Disconnect multi-wire IBP cable with ferrite in the area illustrated.4 Cut the tie wrap to the IBP cable in the area shown wit

Removing the EtCO2 and NIBP Modules9650-0804-01 Rev. A ZOLL Propaq M Service Manual 539 Remove five (5) screws and washers from the NIBP unit to relea

54 9650-0804-01 Rev. A14 Remove the NIBP module from the unit.15 Tilt side panel to access the EtCO2 connector and use an orange stick release the tab

Removing the Monitor Board and SpO2 Modules9650-0804-01 Rev. A ZOLL Propaq M Service Manual 55Removing the Monitor Board and SpO2 ModulesTool Required

PREFACE2 9650-0804-01 Rev. AChapter 6—Functional Description provides technical descriptions for the Propaq M major subassembly modules.Appendix A—Pro

56 9650-0804-01 Rev. A3 Lift the monitor board to expose the multi-wire LCD cable on the back side of monitor board and disconnect it.4 Remove three (

9650-0804-01 Rev. A ZOLL Propaq M Service Manual 57Chapter 4Life Cycle CountersOverviewThis chapter contains instructions for setting life cycle count

CHAPTER 4LIFE CYCLE COUNTERS58 9650-0804-01 Rev. ACO2On the Propaq M, do the following:1. Press the Setup quick access key ( ).2. Use the navigation k

9650-0804-01 Rev. A ZOLL Propaq M Service Manual 59Chapter 5 Replacement PartsOverviewThis section contains a listing of the replacement parts availab

CHAPTER 5REPLACEMENT PARTS60 9650-0804-01 Rev. AReplacement PartsPART NUMBER QUANTITY DESCRIPTION705519 1 Handle Top705517 1 Handle Bottom705510 4 Scr

Replacement Parts9650-0804-01 Rev. A ZOLL Propaq M Service Manual 617772-0005-01 1 Oridion Assembly7772-0006-01 1 Monitor Board Assembly7772-0009-01 1

CHAPTER 5REPLACEMENT PARTS62 9650-0804-01 Rev. A

9650-0804-01 Rev. A ZOLL Propaq M Service Manual 63Chapter 6Functional DescriptionOverviewThis chapter contains functional descriptions of the compone

CHAPTER 6FUNCTIONAL DESCRIPTION64 9650-0804-01 Rev. AMain Processor (MP)The MP section controls the user interface, connectivity needs, as well as dat

Overview9650-0804-01 Rev. A ZOLL Propaq M Service Manual 65SPO2 ModulePropaq M supports the Nellcor NELL-3 OEM Module that mounts to the Monitor board

Conventions9650-0804-01 Rev. A ZOLL Propaq M Service Manual 3Conventions WARNING! Warning statements describe conditions or actions that can result in

CHAPTER 6FUNCTIONAL DESCRIPTION66 9650-0804-01 Rev. A

9650-0804-01 Rev. A ZOLL Propaq M Service Manual 67Appendix AOverviewThis appendix includes the following diagrams:• Propaq M Electrical Hardware Inte

68 9650-0804-01 Rev. APropaq M Electrical Hardware Interconnect Diagram

Propaq M Signal and Power Interconnect Schematic9650-0804-01 Rev. A ZOLL Propaq M Service Manual 69Propaq M Signal and Power Interconnect Schematic

70 9650-0804-01 Rev. A

9650-0804-01 Rev. A ZOLL Propaq M Service Manual 71Appendix BOverviewThis appendix includes simulators and settings that may be used to assess the per

72 9650-0804-01 Rev. ABio-Tek Instruments BP PumpAdult/Pediatric ModeNeonate ModeBio-Tek Instruments BP Pump2Adult/Pediatric ModeNeonate ModeFastBP St

Overview9650-0804-01 Rev. A ZOLL Propaq M Service Manual 73DNI Nevada CuffLinkAdult/Pediatric ModeClinical Dynamics Smart ArmAdult/Pediatric ModeNeona

74 9650-0804-01 Rev. A

PREFACE4 9650-0804-01 Rev. ATechnical Service for International CustomersInternational customers should return the unit in its original container to t

9650-0804-01 Rev. A ZOLL Propaq M Service Manual 5Chapter 1 Maintenance TestsPropaq M OverviewThis chapter includes step-by-step procedures for the fo